BTPHJ - S-9984A EPOXY QUIK PATCH MIXING LIQUID

  • MSDS: BTPHJ
  • Manufacturer: KELLEY TECHNICAL COATING INC
  • Product Name: S-9984A EPOXY QUIK PATCH MIXING LIQUID
  • National Stock Number: 8040-00F035974
Product Identification

Product ID:S-9984A EPOXY QUIK PATCH MIXING LIQUID
MSDS Date:05/30/1992
FSC:8040
NIIN:00F035974
MSDS Number: BTPHJ

Responsible Party
KELLEY TECHNICAL COATING INC
1445 S 15TH ST
LOUISVILLE, KY 40210-3726
US

Emergency Phone: 502-636-2561/502-896-1218

Info Phone: 502-636-2561/502-363-9721

Cage: 8N412

Contractor
KELLEY TECHNICAL COATING INC
3726 LOUISVILLE, KY 40210-1837 US

Telephone: 502-636-2561

Cage: 8N412

Ingredients

EPOXY, CURED

Hazards

Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:LIQUID MAY CAUSE BURNS. SKIN CONTACT
W/LIQUID MAY PRODUCE IRRITATION. EXPOSURE TO VAPOR, MAY RESULT TO
EYES, NOSE & THROAT IRRITATION. NARCOTIC EFFECTS OCCUR AT HIGHER
CONCENTRATIONS OF VAPOR.
Explanation of Carcinogenicity:NONE
Effects of Overexposure:LIQUID MAY CAUSE BURNS. SKIN CONTACT W/LIQUID
MAY PRODUCE IRRITATION. EXPOSURE TO VAPOR, MAY RESULT TO EYES, NOSE
& THROAT IRRITATION. NARCOTIC EFFECTS OCCUR AT HIGHER
CONCENTRATIONS OF VAPOR.
Medical Cond Aggravated by Exposure:PRE-EXISTING RESPIRATORY, EYE &
SKIN CONDITIONS.

First Aid

First Aid:EYES: IRRIGATE IMMEDIATELY & THOROUGHLY W/WATER FOR 15 MINS.
SKIN: FLUSH IMMEDIATELY W/WATER. INHALATION: REMOVE FROM EXPOSURE,
TREAT SYMPTOMATICALLY. OBTAIN MEDICAL ATTENTION IN ALL CASES.

Fire Fighting

Flash Point Method:TCC
Lower Limits: 1.2
Extinguishing Media:FOAM, DRY CHEMICAL, CO2, WATER FOG
Fire Fighting Procedures:AVOID SOLID STREAM OF WATER, USE FOG FOR
COOLING .
Unusual Fire/Explosion Hazard:FLAMMABLE VAPORS MAY FORM EXPLOSIVE
MIXTURES W/AIR.

Accidental Release

Spill Release Procedures:ELIMINATE ALL IGNITION SOURCES. FLUSH AWAY
W/WATER SPRAY. SMALL: MAY BE COLLECTED W/ABSORBENT MATERIAL.

Handling

Handling and Storage Precautions:FLAMMABLE LIQUID. KEEP FROM IGNITION
SOURCES. KEEP CONTAINER CLOSED. AVOID EYE/PROLONGED SKIN CONTACT &
INHALATION OF HIGH CONCENTRATIONS OF VAPORS.
Other Precautions:USE W/ADEQUATE VENTILATION TO MAINTAIN VAPOR
CONCENTRATIONS BELOW THE TLV OF 50 PPM. PRODUCT RESIDUE MAY REMAIN
AFTER IT HAS BEEN REMOVED FROM ITS CONTAINER. DON'T REUSE EMPTY
CONTAINER W/OUT COMMERCI AL CLEANING/RECONDITIONING.

Exposure Controls

Respiratory Protection:WEAR A NIOSH-APPROVED RESPIRATOR FOR ORGANIC
VAPORS.
Ventilation:LOCAL EXHAUST/MECHANICAL (GENERAL): RECOMMENDED.
Protective Gloves:REQUIRED
Eye Protection:SAFETY GLASSES
Other Protective Equipment:SAFETY SHOWER, EYE BATH
Supplemental Safety and Health

Chemical Properties

Vapor Density:>1
Evaporation Rate & Reference:SLOWER THAN BU AC

Stability

Stability Indicator/Materials to Avoid:YES
OXIDIZING MATERIALS
Stability Condition to Avoid:HEAT, SPARKS, OPEN FLAME
Hazardous Decomposition Products:CO2 & CO

Disposal

Waste Disposal Methods:MIX W/A COMPATIBLE CHEMICAL & INCINERATE.
DISPOSE OF IN ACCORDANCE W/LOCAL, STATE & FEDERAL REGULATIONS.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.